Aristel SLT70 User's Guide download pdf (Page 9)

Telephone Router Setting User Guide

Aristel Networks Pty Ltd 4x4 PABX/Router User Guide and Setting Tool Programming Rev 3.6

For Example to set up a Hot Line from Ext 12 to Ext 13, from Ext12

1. * # * 0000 - hear a beep Enter into programming mode

2. 732*13 - Hear one beep In this case 2 represents Extension 12 .

Hot Line destination is 13

3. 712# - Hear one beep Enable Hot Line

4. Hangup.

To cancel Hot Line for Ext12, go off hook from Ext12 and enter the

following:

1. *#*0000 - hear one beep Enter programming mode

2. 702# Cancel Hotline on Ext 2, i.e Ext12

Example: Set up Extension 12 to call an external number xxxxxxxx as hot

line.

From an Extension enter the following:

* # * 0000 (Enter into programming)

732xxxxxxxxx# (Register the number on Extension 2)

Hang up now

* # * 0000 (Enter into programming again)

712# (Activate Hot Line on Extension 2)

4. Command Table

All commands shown below can be set from any extension telephone .

Enter into programming state with command * # * plus Password.

Go Off-hook and dial * # * 0000 to enter into programming state.

The default Password is “0000”.

Then enter the respective command. All commands end with a #

If the command had been set correctly, the system sounds one tone “Du”.

If the command had been set incorrectly, it sounds 3 tones “DuDuDu”.

If there is an error inputting a command, press *and then input command again.

Simply hang up at the end to terminate programming.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

No comments

Aristel SLT70 User's Guide Page 9